|
9
|
Ultra
Version M 22-April-2012
|
Ultra
LASER
HEAD
ICE450
FRONT PANEL
REMOTE BOX
ICE450
BACK PANEL
2.0 Connecting
Standard Upright Ultra System
CAUTION:
Do not power up the laser system
before thoroughly reading the installation and
operation instructions.
1. Verify that the ICE key switch is turned OFF.
2. Connect the I/O cable between the ICE rear panel
and the Laser Head. All connectors are unique and
keyed to ensure proper connection. Secure all non-
locking connectors using the captive fasteners.
CAUTION:
These connections carry high
voltage and high current. Ensure that the
connectors are fully inserted and the collars or
screw locks are fully engaged or interlock faults
may result.
3. Remove the blue plastic shipping covers from the
coolant ports. Keep them for reuse.
4. Connect the coolant lines between the back panel
of the ICE and the Laser Head. Connect red to red
and blue to blue. Coolant flows from the ICE into
the Laser Head via the blue hose and returns to the
ICE via the red hose.
5. Verify that the Emergency Stop switch on the
Remote Box is in the OUT position.
6. Connect the Remote Box to the ICE front panel.
7. Connect the AC Mains power cable from the ICE
back panel to 100-240 VAC, 50/60 Hz power.
CAUTION:
Ensure the system is connected to
the proper voltage. The voltage rating is marked
on the ICE back panel. Operating the system at
the incorrect voltage may damage the system.
Ensure that the power outlet used is properly
grounded.
TO
100-240 VAC,
50/60 HZ
POWER
I/O CABLE
COOLANT
LINES
EMERGENCY STOP
Figure 2:
Connecting a Standard Ultra System
