Q24
Tape
Library
Installation
and
Operations
Manual
© Copyright QUALSTAR 2014
82
5.5
Removing
the
library
controller
Adhere
strictly
to
the
following
steps
to
remove
a
power
supply:
1.
Power down the library by pressing the power button on the front panel.
2.
Remove the power cord from the rear panel of the library.
3.
Remove all cables from the library controller on the rear panel of the library.
4.
Loosen the blue thumbscrews located on the library controller with your fingers.
5.
Pull the library controller straight out of the library as shown below.
Figure
65
Remove
the
library
controller
6.
To store or ship the removed library controller, repackage it in the original or replacement device
packaging materials.
5.6
Replacing
the
library
controller
Use this procedure to replace the library controller with another library controller:
1.
Remove the library controller from the library, as described above.
2.
To install the new library controller, see
Section
2.10