Q24
Tape
Library
Installation
and
Operations
Manual
© Copyright QUALSTAR 2014
83
5.7
Removing
the
power
supply
Adhere
strictly
to
the
following
steps
to
remove
a
power
supply:
1.
Power down the library by pressing the power button on the front panel.
2.
Remove the power cord on the rear panel of the library.
3.
Loosen the blue thumbscrews located on the rear of the power supply with your fingers.
4.
Pull the power supply straight out of the library as shown below.
Figure
66
Remove
the
power
supply
5.
To store or ship the removed power supply, repackage it in the original or replacement device
packaging materials.
5.8
Replacing
the
power
supply
Use this procedure to replace the power supply with another power supply:
1.
Remove the power supply from the library, as described above.
2.
To install the new power supply, see
Section
2.11
5.9
Servicing
a
magazine
To
remove
a
magazine,
adhere
to
the
following
steps:
1.
Unlock the appropriate magazine, using:
‐
OCP, see
Section
3.1.7
‐
RMU, see
Section
3.2.8.3
2.
Emergency release, if you are not able to unlock the magazine with the OCP or RMU,
see
Section
4.4
3.
Pull the released magazine out of the library.
4.
Remove all tape cartridges from the magazine.
5.
To store or ship the removed magazine, repackage it in the replacement device packaging
materials.