Q24
Tape
Library
Installation
and
Operations
Manual
© Copyright QUALSTAR 2014
14
3.
Before installing the library controller, inspect its connectors. Ensure that the connectors are
intact, free of any foreign objects, and have no cracks or deformed or bent contacts.
4.
Insert the library controller on the alignment rails and push it into the bay until it seats itself
against the back of the library.
Figure
16
Install
a
library
controller
5.
Tighten the blue captive screws with your fingers to secure the library controller.
2.11
Installing
a
power
supply
The power supply is installed from the rear of the library. If the library does not have a power supply
installed, install it in the left power supply bay now.
Required
tool:
#2 Phillips screwdriver
To
install
a
power
supply:
1.
Locate the power supply bay on the left side of the rear panel of the library.
2.
If present, loosen the screws and remove the power supply bay cover.
3.
Before installing the power supply, inspect its connectors. Ensure that the connectors are
intact, free of any foreign objects, and have no cracks or deformed or bent contacts.
Figure
17
Install
a
power
supply
