quadient DS-77iQ, Manual

Page: 40 / 156

g/m2 or less, a document length of 12 inch (305 mm) or higher, and for situations
where Mode 2 is not functioning properly. In all other cases use Mode 2.
• Document offset (A in the figure): the extend to which documents are not overlapping
in the vertical transport. In the vertical transport of documents fed by the various
feeders, the documents are partially overlapping each other. This to make sure that
the documents are properly aligned in the collator area. The default value is 50
mm (2.0 inch). The document offset can be varied between 20 mm (0.8 inch) and
250 mm (9.8 inch).
• BRE offset: in the case of offset is “yes”, the last document that was added to the
set is shifted from the rest of the set (offsetting, see below).
Explanation of BRE offset: if a BRE is longer than the set fold but shorter than the envelope
height, this BRE can get folded (A in the figure). Under certain conditions (see below) you
can prevent the BRE from being folded. In the case of offset “yes”, the BRE is held back
during a certain distance (B in the figure). This means that the trailing edge of the BRE
leaves the collator last. The document is not folded. During the insertion into the envelope
the documents of the set are aligned.
36
| Page 36 | Jul-11-2022 07:45 | Working with Jobs
4
English