Qlogic SANsurfer iSCSI HBA CLI, User Manual

Page: 120 / 184

A – Port- and HBA-level Parameters
Port-level Parameters
A-4 SN0054621-00 E
S
IPv4_TOS_Enable on, off TOS_
ENABLE IPv4 type of service QLA405 x and QLE406 x
only.
IPv4_TOS 0–255 IPV4TOS
Controls the value of the type of service (TOS)
field of IPv4 headers transmitted by the firmware
on iSCSI connections. The firmware uses the
value when transmitting IPv4 TCP packets on
iSCSI connections.
IPv4_TTL 0–255 IPV4TTL Time-to-Live (in hops). Each router decrements
TTL before transmitting it. Router discards the
datagram when TTL = zero.
IPv6_MCast_Listnr_
Disco_Enable on, off IPV6MLDEN When enabled, the firmware supports the IPv6
Multicast Listener Discovery (MLDv1) protocol
by sending MLD Listener Report and Listener
Done messages. When disabled, the firmware
firmware does not support the MLD protocol.
IPv6_Addr_Local_Link IPv6
address IPLL Contains the IPv6 link local address.
IPv6_Addr_Routable0 IPv6
address IPR0 Contains the IPv6 first manually-configured
routable address.
IPv6_Addr_Routable1 IPv6
address IPR1 Contains the IPv6 second manually-configured
routable address.
IPv6_DAD_Count 0–255 IPV6DAD Specifies the count for the IPv6 Duplicate
Address Detection (DAD) process.
IPv6_Gratuitious_Neighbor
_Ad_Enable on, off IPv6GNAE When enabled, the firmware issues a series of
gratuitous neighbor advertisement messages for
its IP during initialization, when a valid IP
address has been configured.
IPv6_Hop_Limit
0–255
b
IPV6HL Specifies the IPv6 hop limit value to be used in
IPv6 TCP packets transmitted from the firmware
on iSCSI connections. Receiving an IPv6 router
advertisement with a nonzero value in the cur-
rent hop field will cause this field to be overwrit-
ten with the current hop limit advertised by the
router.
Table A-1. Port Settings (Continued)
Parameter Value Alias Description