Qlogic SANsurfer iSCSI HBA CLI, User Manual

Page: 86 / 184

5 – Non-Interactive Mode Commands
5-2 SN0054621-00 E
S
Table 5-1 defines the command variables. The command section to which they
apply. describes command-specific variables.
The positional parameters vary, depending on the command option specified. For
example, to display an HBA’s configured settings, use the command option
-C
,
followed by the port instance number (positional parameter). In contrast, the
command for providing general information,
-g
, has no positional parameters.
In non-interactive mode, most changes made to the port instance become
effective immediately. This sometimes will cause the HBA to reset, as specified in
the command description. Be sure the system is prepared for a HBA reset before
making changes.
Table 5-1. Non-interactive Command Variables
Variable Definition
hba_port_inst The system port (formerly HBA number)
Target ID Target ID
LUN ID Logical unit number (0–255)
CHAP Number Challange handshake authentication protocol (CHAP) num-
ber
CHAP Name Null-terminated CHAP name, which is sent by the port
instance when responding to the CHAP challenge
CHAP Secret CHAP secret, which is used by the port instance when gener-
ating the CHAP response
Boot Target The target ID of the target device from which to boot
Boot LUN The LUN of the boot device
NOTE:
„ The commands are case sensitive. For example,
-g
is not the same as
-G
.
„ Only one command line option per input file is valid.
„ <hba_port_inst> is an instance number from the list of all iSCSI HBA
ports in the system. You can see this list with the command
-i
.