Qlogic SANsurfer iSCSI HBA CLI, User Manual

Page: 100 / 184

5 – Non-Interactive Mode Commands
Non-interactive Commands
5-16 SN0054621-00 E
S
For information on the interactive version of this command, see “Import HBA
Configuration (CLI Option -import)” on page 4-10 .
-ipdhcp
(Configure IP Settings)
To set the HBA to get its IP address, subnet mask, and gateway from the DHCP
server, enter the
-ipdhcp
command as follows:
-ipdhcp <hba_port_inst> [- option ]
If the HBA port had prior values set manually, the DHCP values replace them.
Where
[ option ]
includes:
For information on the interactive version of this command, see “Configure IP
Settings (CLI Option -ipdhcp)” on page 4-21 .
-isns
(Configure iSNS Settings)
To configure the iSNS settings for QLA4010 and QLA405 x , enter the
-isns
command as follows:
I
= Configure the iSCSI name.
T
= Configure the targets.
C
= Configure the CHAP table.
B
= Configure the boot parameters. (only valid when
T
[tar-
gets] parameter is also specified).
Filename
= The XML file with the HBA configuration. See “-save
(Save Host Configuration)” on page 5-28 ).
-DISN4
= Disable IPv4 network
-IPV4DHCP
= Set DHCP ON
-IP
= Set IP Address
-IPNM
= Set IP Netmask
-IPGW
= Set IP Gateway
-DISN6
= Disable IPv6 Network Setup
-IPLLA
= Set Local link Address Automatically
-IPLL
= Set Local link Address Manually
-IPRA
= Set IPR0 and IPR1 Automatically
-IPR0
= Set Routable Address 0 Manually
-IPR1
= Set Routable Address 1 Manually
-IPRAA
= Set Router Address Automatically
-IPRR
= Set Router Address Manually