Qlogic SANsurfer iSCSI HBA CLI, User Manual

Page: 62 / 184

4 – Interactive Mode Commands
Port Level Info & Operations Menu
4-28 SN0054621-00 E
S
IPv6_Port [3260] :_
IPv6_Gratuitious_Neighbor_Ad_Enable [off] :_
IPv6_Redirect_Enable [off] :_
Configure IPv6 TCP Settings
Select the Configure IPv6 TCP Settings option to view each current IPv6 TCP
setting and, optionally, changing a setting. For example:
IPv6_Nagle [off] :_
IPv6_TCP_Time_Stamp [on] :_
Legacy QLA4010 Restore Default Port Settings
Select the Legacy QLA4010 Restore Default Port Settings option to reinstate
default port settings to any QLA4010 HBAs in the system. When you enter this
option, the following warning appears:
Warning: This function is resetting the firmware to its default
configuration. These changes will not become permanent until the
HBA settings are saved.
Press the enter key to continue.
Port Restore Factory Defaults
(CLI Option -rdh)
Use the Port Restore Factory Defaults option to reset the firmware for a single
port to the factory default values. Be sure to select both Save changes and reset
HBA and then Refresh afterwards; otherwise, the changes will not take effect.
This option updates the HBA factory default settings for the following HBA
modules:
„ Firmware parameters
„ Network settings (IP, netmask, and so on)
„ iSCSI name
„ Target settings
„ CHAP settings
„ NVRAM settings
„ IPsec settings
After selecting this option, you are asked if you want to restore all of the factory
defaults in the preceding list. Do one of the following:
NOTE:
This option is not supported in the QLA4010 HBA.