Qlogic QLE2740L-DEL, User Manual

Page: 53 / 135

3–Fibre Channel Configuration
Using Fast!UTIL for Custom Configuration
38 BK3254601-00 C
Loop Reset
Delay
0–60
seconds 5
seconds
After resetting the loop, the firmware refrains from initiating
any loop activity for the number of seconds specified in this
setting.
Adapter Hard
Loop ID
Enabled,
Disabled Disabled If the Adapter Hard Loop ID setting is enabled, the adapter
attempts to use the ID specified in the Hard Loop ID setting.
Hard Loop ID
0–125 0 If the Adapter Hard Loop ID setting is enabled, the adapter
attempts to use the ID specified in this setting.
Connection
Options
0, 1, 2 2 This setting defines the type of connection:
 0—loop only (for the 8Gb data rate)
 1—point-to-point only (for the 8Gb, 16Gb, and 32Gb
data rate)
 2—loop preferred, then point-to-point (for the 8Gb and
16Gb data rate)
Fibre
Channel Tape
Support
Enabled,
Disabled Enabled This setting enables FCP-2 recovery.
Data Rate
2, 4, 5, 6 2 This setting determines the data rate:
 2—The adapter auto-negotiates and determines the data
rate.
 4—The adapter runs at 8Gbps.
 5—The adapter runs at 16Gbps. Loop mode is not sup-
ported.
 6—The adapter runs at 32Gbps.
Table 3-1. Adapter Settings (Continued)
Setting Values Default Description