Safety
UM Pallet stacker Prmk10-PS v2.0 EN
13
Switch off air service unit before starting any maintenance or repair tasks.
Replace damaged or defective parts before putting the machine back into operation.
Changes and modifications that may affect the safety of the machine can only be carried
out when these changes and modifications comply with the relevant regulations,
legislation, directives and recognized industry standards.
If changes and modifications are outside the scope of specifications given by Qimarox in
this manual and Qimarox has not granted permission changes and modifications, then the
changes and modifications will entirely be the responsibility of those persons responsible
for carrying out the changes and modifications.
Electrical installation tasks must only be carried out by qualified personnel.
Safety devices should never be bypassed or removed.
Remove any tools or objects left on or in the machine before starting the machine.
After having completed maintenance activities, always put all safety provisions (fencing,
covers and other) that have been removed in place again.
Take the appropriate measures for safety when working at heights.
Pallet quality
A good quality of pallet is essential for the efficiency and safety of the machine. Pallets should
be suitable for automated handling and stacking. No missing parts, no nails, screws or
splinters sticking out that might disrupt the handling or stacking of the pallet.
WARNING
Danger of products or pallet falling. Unsuitable pallets might cause the
loaded pallet to fall down or sideways or might cause products to fall
from the pallet.
WARNING
Danger of products or pallet falling. Because of their size, the forks may
apply big forces on relatively small parts of the pallet. One should
always check is the pallet type is strong enough for these forces.
Pallet load quality
A good and stable pallet load is essential for the efficiency and safety of the machine. The
products on the pallet should be suitable for automated handling and stacking. The load must
be able to carry the weight of a pallet stacked on top of it.
Also the top of the pallet load must be level and have enough carrying surface for the
underside of the pallet on top.
WARNING
Danger of products or pallet falling. Unsuitable products or pallet load
might cause the loaded pallet to fall down or sideways or might cause
products to fall from the pallet.
Pallet clamp position
To ensure that the pallets are stacked safely, the distance between the pallet clamps must be
inserted according to the size of the pallet. There must be approximately 10mm distance
between forks and the side of the pallet.
