12
AS40 Conveyors | Installation & Maintenance Instructions
u
Pivot Drive Mounting Package
The Drive Package will ship separate from the conveyor. For Standard Duty Drives the speed reducer and motor will ship installed on the drive mounting package.
3
x
1
Loosen two set screws in drive
mounting plate.
2
Rotate drive mounting plate
into workable position.
3
Remove and discard three
socket head cap screws from
drive side bearing plate. (Do not
remove bearing plate)
4
Align pins on mounting plate
to holes on bearing plate and
slide assembly over shaft.
3
x
3
x
4
x
5
Install flat head screws into
countersunk holes.
6
Tighten screws in countersunk
holes.
7
Loosen four hex nuts holding
gearbox in position.
8
Tighten jacking screw to
allow gearbox to move toward
conveyor.
2
x
9
Remove tape holding key in
place. (Do not remove Key)
10
Slide top sprocket onto
conveyor‘s output shaft
and key.
11
Tighten set screws to
secure top sprocket.
12
Install timing belt over
sprockets.
