Pulsar Flow Monitor, Instruction Manual

Page: 50 / 61

Page
44
Totaliser Parameters
Setup
P822 Totaliser Enable
This parameter determines if the totaliser is enabled or not, the
options are as follows:
Option Description
0 = No (Default) Totaliser is disabled
1 = Yes Totaliser enabled
P823 Totaliser Decimal
This parameter determines the number of decimal places in the
totaliser during run mode. It can be set between 1 and 3.
Default = 2
P824 Totaliser Multiplier
Use this parameter if the totaliser increments by to large or
small amount, enter the factor by which the actual flow rate
is multiplied by before incrementing the totaliser.
E.g. if flowrate is being calculated and displayed in ltrs/second and it is
desired to increment the totaliser in cubic metres select 7 = *1000.
When viewing, the totaliser display will state, “Units are: L*1000”,
and the totaliser will be incremented every 1000 litres
Option Description
1 = 1/1000 Totaliser will increment every 1/1000
th
units of flow
2 = 1/100
Totaliser will increment every 1/100
th
units of flow
3 = 1/10 Totaliser will increment every 1/10
th
units of flow
4 = *1 (Default)
Totaliser will increment every 1 units of flow
5= 10 Totaliser will
increment every 10 units of flow
5 = * 10
Totaliser will increment every 10 units of flow
6 = * 100
Totaliser will increment every 100 units of flow
7 = * 1000 Totaliser will increment every 1000 units of flow
8 = * 10000 Totaliser will increment every 10,000 units of flow
9 = * 100000 Totaliser will increment every 100,000 units of flow
10 = * 1000000
Totaliser will increment every 1,000,000 units of
flow
11 = 1/10000
Totaliser will increment every 1/10,000 units of
flow
12 = 1/100000
Totaliser will increment every 1/100,000 units of
flow
13 = 1/1000000
Totaliser will increment every 1/1,000,000 units of
flow