Pulsar Flow Monitor, Instruction Manual

Page: 22 / 61

Page
16
Program Mode
This mode is used to set up the Flow Monitor or change information already
set. You must use either the on-board keypad (standard) or alternatively the
unit can be set up with a Hand Held Calibrator (optional), which must be
connected to the
Flow Monitor via the RS 232 Serial Interface.
Entering a value for each of the parameters that are relevant to your
application provides all the programming information.
How to Access Program Mode
To enter program mode , you simply enter the passcode, via the keypad,
followed by the
ENTER
key. The default passcode is 1997 , so you would
press the following:
Note
There is a time-out period of 15 minutes when in program mode , after
which time run mode will be resumed if you do not press any keys.
There are two means of editing parameters, directly or using the menu
system. Each is now described.
Using the Menu System
The menu system has been designed to make the changing of parameters
very simple. There are two levels of menu:
Main Menu and Sub Menu .
On the display there is a line of text that shows the menu system. Pressing
the arrow keys scrolls the display between the top-level menu items, (as
shown below, starting at Quick Setup).
1 9 9 7
Application Relays Display
System Test
mA Output
Totaliser