Pulsar Flow Monitor, Instruction Manual

Page: 21 / 61

Page 15
There are two main operating modes for your Flow Monitor , Run Mode
and Program Mode . There is also a Test Mode , used for checking the set-
up. All modes are now described.
Run Mode
This mode is used once the Flow Monitor has been set up in program mode.
It is also the default mode that the unit reverts to when it resumes operation
after a power failure.
When the Flow Monitor is switched on for the first time, it will attempt to
initiate the FlowPulse sensor and will display a message similar to
“Update….” and follow by parameter number. All relays by default are
switched off and once the FlowPulse is initialised, the display will show the
current flow or velocity and the measurement unit.
After programming is complete, any relays that are set will operate when the
measurement reaches the relevant setpoint.
Note
If the FlowPulse sensor is not detected, the Flow Monitor will automatically
retry to connect to it.
LED’s
There are two LED’s that can be seen through the lid of the Flow Monitor
enclosure, which will indicate the operational status of the relays whilst in
RUN mode, as follows:
LED 1 LED 2 Run Mode
Off Off Relays are in there OFF state.
Constant On Off Relay 1 in its ON state
Off Constant On Relay 2 in its ON state
Flash Off No sensor detected
Off Flash System error (clock or EE error)