Proximus Forum 5010, User Manual

Page: 77 / 180

Configuration on the Web Console
Commissioning 75
Commissioning with configured MAC addresse
You will find the MAC address on the label attached to the back of the SIP
system telephone. If you configure the SIP system telephone with it’s MAC
address, the device is ready for use after starting up.
Commissioning without entering the MAC address
To configure the SIP system telephone without entering a MAC address, you
must set the DHCP mode to
Dynamic and static address assignment , either
for all devices ( All setting) or for all SIP system telephones ( with configured
MAC only and all SIP system devices setting). You can change the DHCP
mode in the Configurator > Network > DHCP menu.
In the VoIP Phones dialogue, a part of the MAC address is already set. You do
not need to remove the preset value if you configure the SIP system
telephone without MAC address.
When configuring the SIP system telephone without MAC address, it is
necessary to perform a one-time login procedure after the device is started.
1. Enter the call number of the SIP system telephone. Confirm the input with
the “arrow down” navigation key.
2. Enter the user PIN. The default PIN for a user on the Forum 500 /
Forum 5000 communications system is “0000”. Confirm the input with
the “arrow down” navigation key.
The SIP system telephone restarts to apply the configured call number.
Internet Address
When operating the DHCP server in the Static address assignment mode,
you need to enter an IP address when configuring a SIP system telephone.
This IP address is then automatically entered into the list of the DHCP entries
that is managed by the communications system. This configuration is
recommended to prevent conflicts when putting the SIP system telephones
into service.
If you operate the DHCP server in the Dynamic and static address
assignment mode, entering an IP address is optional. In this case, the terminal
will automatically be assigned an IP address by the DHCP server when
started. This may mean – depending on the DHCP configuration – the IP
telephone cannot be started.