PRONAR T682, Manual

Page: 68 / 131

Pronar T682, T682/1 SECTION 4
4.4
•
Switch on individual lights, check correct operation of electrical system.
•
Release tractor's parking brake. Perform test drive. While driving, check the
operation of the trailer brake.
•
Stop tractor (do not turn off the engine), immobilise tractor with parking brake.
•
Start PTO with a speed of not more than 540 rpm.
•
Using the controller, open the tailgate of the load box.
•
Using the controller, tip the load box. Lower the load box and close the tailgate.
•
Disengage PTO drive
•
Use the manifold in the tractor to extend the steering lock hydraulic cylinders.
If during test run worrying symptoms occur such as:
•
excessive noise and abnormal sounds originating from the rubbing of moving
elements,
•
leaky brake system, hydraulic oil leaks,
•
incorrect operation of brake cylinders,
•
other faults,
stop operating the trailer and do not operate it until the malfunction is corrected. If a fault
cannot be rectified or the repair could void the warranty, please contact retailer for additional
clarifications or to perform the repair.
4.1.4 PREPARING THE TRAILER FOR NORMAL USE
Scope of inspection activities
•
Visually inspect if the tyres are properly inflated. In case of doubt, carefully check
tyre pressure.
•
Check technical condition of drawbar eye.
•
Check correctness of electrical system operation.