PRONAR T682, Manual

Page: 37 / 131

SECTION 2 Pronar T682, Pronar T682/1
2.11
•
Reckless driving and excessive speed may cause accidents.
2.1.7 TYRES
•
When working with tyres, the trailer should be immobilised with parking brake and
secured against rolling by placing chocks under wheel. Wheels can be taken off
the trailer axle only when the trailer is not loaded.
•
Repair work on the wheels or tyres should be carried out by persons trained and
entitled to do so. This work should be carried out using appropriate tools.
•
Inspect tightness of wheel nuts after the first use of the trailer, every 2 - 3 hours
during first month of work and then every 30 hours of use (travel). The inspection
should be repeated individually if a wheel has been removed from the wheel axle.
Wheel nuts should be tightened according to recommendations provided in
section 5 MAINTENANCE .
•
Avoid potholes, sudden manoeuvres or high speeds when turning.
•
Check the tyre pressure regularly. Air pressure in tyres should be also checked
during the whole day of intensive work. Please note that higher temperatures
could raise tyre pressure by as much as 1 bar. At high temperatures and
pressure, reduce load or speed. Do not release air from warm tyres to adjust the
pressure or the tyres will be underinflated when temperatures return to normal.
•
Protect tyre valves using suitable caps to avoid soiling.
2.1.8 OPERATING PTO SHAFT.
•
The user should thoroughly acquaint himself with the PTO shaft Operator's
Manual and adhere to the recommendations contained in it.
•
The machine may only be connected to the tractor by appropriately selected PTO
shaft. Use PTO shaft recommended by the Manufacturer.
•
The drive shaft must be equipped with guards. Do NOT use the shaft with
damaged or missing guards. Before starting the machine, always ensure that all
the safety guards are in good condition and in place. Damaged or incomplete
sub-assemblies must be exchanged for original new ones.