Pronar RC2100-2
SECTION 4
4.4
or other faults, find the cause of the problem. If a fault cannot be rectified or the repair could
void the guarantee, please contact the dealer for additional clarifications or to make a repair.
DANGER
Careless and incorrect use and operation of the trailer, and non-compliance with the
recommendations given in this operator's manual is dangerous to your health.
The trailer must never be used by persons who are not authorised to drive agricultural
tractors, including children and people under the influence of alcohol or other drugs.
Non-compliance with the safety rules of this Operator’s Manual can be dangerous to the
health and life of the operator and others.
After completion of test drive check tightness of wheel nuts.
4.2
HITCHING AND UNHITCHING THE TRAILER FROM
TRACTOR
Ensure that all connections (electric, hydraulic) and the hitch of agricultural tractor meet the
requirements of the low chassis trailer Manufacturer. Otherwise, the trailer should not be
hitched to the tractor.
In order to hitch the trailer to the tractor, perform the actions below in the sequence
presented. Machine must be immobilised by parking brake.
Hitching to tractor
Immobilise trailer with parking brake.
Position agricultural tractor directly in front of drawbar eye.
Adjust the hight of tractor hitch to enable hitching the trailer (support leg).
Connect the conduit marked with decal (7) – figure (4.2) to socket in tractor –
supply of the support's hydraulic system (hydraulic support).
Set hydraulic valve (5) to „O” position (hydraulic support).
Adjust the height of the drawbar with regard to the tractor hitch using
distributor of the tractor's hydraulic system (by lowering or sliding the support
foot) (hydraulic support).
Summary of Contents for RC2100-2
