PRONAR PT510, Operator'S Manual, Page: 88 / 133

Pronar PT510 SECTION 4
4.24
FIGURE 4.6 Chute
(1) chute slide gate, (2) chute, (3) lever, (4) locking bolt
The rear load box wall is equipped with the chute slide gate (1) – figure (4.6) and chute
opening (2) (additional equipment) for unloading bulk materials. Chute design allows very
accurate dosing of the material to packaging (sacks, boxes etc.).
The opening gap can be controlled using lever (3). In order to do that loosen the bolt
interlocking slide gate (4), open the slide as required and lock again using the bolt. When
unloading through the chute do not open wall locks or wall extension locks and tipping of the
load box must be done very slowly and without jerking. Raising the load box quickly will exert
large pressure on the rear part of the load box due to displacement of the carried material
and could compromise trailer's stability.
While unloading high-volume materials be especially careful. Do NOT tip load box on uneven
or wet ground and move and jerk trailer during unloading. Bulky materials are normally