PRONAR PT510, Operator'S Manual

Page: 67 / 133

SECTION 4 Pronar PT510
4.3
4.1.2 PREPARING THE TRAILER FOR THE FIRST HITCHING TO TRACTOR
Preparation
Check all the trailer's lubrication points, lubricate the machine as needed
according to recommendations provided in section 5.
Check if the nuts and bolts fixing the wheels and drawbar are properly
tightened.
Drain air tank of the braking system.
Ensure that pneumatic, hydraulic and electric connections in agricultural
tractor are according to the requirements, if not the trailer should not be
hitched to the tractor.
Adjust the height of the drawbar or position of upper transport hitch.
Detailed description can be found in section 5.
Test drive
If all the above checks have been performed and there is no doubt as to the trailer's good
technical condition, it can be connected to tractor. Start the tractor, check all systems and
conduct test run of trailer without load (no load in load box). It is recommended that the
inspection is conducted by two people, one of which should always remain in the tractor cab.
Test drive should be conducted according to the sequence shown below.
TIP
Service operation: hitching/unhitching from tractor, adjustment of draw bar position,
tipping of load box etc. are described in detail in further parts of the Operator's Manual in
sections 4 and 5.
Connect the trailer to appropriate hitch on agricultural tractor.
Connect conduits of braking, electrical and hydraulic systems.
Raise support to transport position.
Switch on individual lights, check correct operation of electrical system.