PRONAR PT510, Operator'S Manual

Page: 124 / 133

Pronar PT510 SECTION 5
5.32
Trailer cleaning guidelines
•
Before washing trailer open all sides and extensions. Carefully clean load remains
from the load box (sweep out or blow out with compressed air), especially where
sides and extensions join and.
•
To clean the trailer, use only clean running water or water with a cleaning
detergent additive with neutral pH.
•
Using pressure washer increases washing effectiveness, but particular care must
be taken during work. During washing, washer nozzle may not be closer than 50
cm from the surface being cleaned.
•
Water temperature should not exceed 55
0
C.
•
Do not direct water stream directly at system elements and equipment of the
trailer i.e. control valve, braking force regulator, brake cylinders, pneumatic,
electric and hydraulic plugs, lights, electrical connections, information and
warning decals, identification plate, conduit connections and lubrication points etc.
Great water jet pressure may damage these elements.
•
For cleaning and maintenance of plastic coated surfaces it is recommended to
use clean water or special preparations designed for this purpose.
•
Do not apply organic solvents, preparations of unknown origin or other
substances, which may cause damage to lacquered, rubber or plastic surfaces. In
the event of doubt it is recommended to make a test on an unseen surface area.
•
Surfaces smeared with oil or grease should be cleaned by application of benzene
or other degreasing agents and then washed with clean water with added
detergent. Comply with recommendations of the Manufacturer of cleaning agents.
DANGER
Carefully read the instructions for application of detergents and maintenance
preparations.
While washing with detergents wear appropriate protective clothing and goggles
protecting against splashing.