PRONAR PRONAR PDT260, Operator'S Manual

Page: 55 / 97

SECTION 4 Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340
4.11
•
operating the hydraulic cylinder, lift the lifting arm together with cutting unit until
cylinder lock (4) is engaged.
•
close lifting cylinder valve (3).
To set the mower in (B) position:
•
Perform the procedure listed for (A) position
•
set valve (5) in open position „I”
•
operating the cylinder, swing the cutting unit sideways,
•
close tipping cylinder valve (5).
To set the mower in (C) position:
•
Lift the mower on three-point linkage
•
set valve (5) in open position „I”
•
operating the cylinder, swing the cutting unit backwards,
•
close tipping cylinder valve (5).
In (C) transport position the mower can be transported only short distances at an
appropriately reduced travel speed.
Three point linkage lower arms must be secured so that mower does not swing sideways.
DANGER
When transporting mower mounted on the tractor, check if tipping cylinder locks are
properly secured and if cylinder valves are set in 0 position– closed (A) — figure (4.4)