PRONAR PRONAR PDT260, Operator'S Manual

Page: 48 / 97

Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340 SECTION 4
4.4
IMPORTANT!
Before connecting the PTO shaft adjust the length of PTO shaft according to the PTO
shaft Operator's Manual.
4.2 CHECKING TECHNICAL CONDITION
When preparing the mower for normal use, check individual elements according to guidelines
presented in table (4.1).
TABLE 4.1 TECHNICAL INSPECTION SCHEDULE
DESCRIPTION SERVICE OPERATION FREQUENCY
Condition of safety guards
Check technical condition of safety
guards, if complete and correctly
mounted.
check if cutter bar and lifting arm
are correctly installed,
check if correctly installed
Technical condition of cutting
blades
Visually inspect and if necessary replace
according to section „CHECKING AND
REPLACING CUTTING KNIVES”
Check lubricating oil level in
intersecting axis gears For details please refer to section
"DRIVE SYSTEM OPERATION”
Check oil level in cutter bar
For details please refer to section
"CUTTER BAR OPERATION”
Technical condition of the
conditioner blades and fingers
(PDT260C, PDT300C) Visually inspect and if necessary replace
according to section „CHECKING AND
REPLACING CUTTING KNIVES”
D
a
ily
Tightening of all main nut and
bolt connections Torque values should be according to
table (5.4) Every six
months
Lubrication
Lubricate elements according to table
LUBRICATION. According to
table (5.3)