PRONAR PRONAR PDT260, Operator'S Manual

Page: 86 / 97

Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340 SECTION 5
5.14
with the use of carbon dioxide (CO
2
), foam or extinguisher steam. Do NOT use water for fire
extinguishing.
Spilt oil should be immediately collected and placed in marked tight container. Used oil
should be taken to the appropriate facility dealing with the re-use of this type of waste.
Flexible hydraulic lines should be replaced after 4 years of use.
5.5 STORAGE
After finishing work, mower should be thoroughly cleaned and washed with water jet. While
washing do not direct a strong water or steam jet at information and warning decals, bearings
or hydraulic lines. Nozzle of pressure or steam washer should be kept at a distance of not
less than 30 cm from cleaned surface.
After cleaning, inspect the whole machine, inspect technical condition of individual elements.
Used or damaged elements should be repaired or replaced.
In the event of damage to the paint coat, clean rust and dust from damaged area, degrease
and then paint with undercoat and after it is dry paint with surface coat paint retaining colour
uniformity and even thickness of protective coating. Until the time of touch-up painting, the
damaged place may be covered with a thin layer of grease or anticorrosion preparation.
Mower should be kept in closed or roofed building.
If the mower shall not be used for a long period of time, protect it against adverse weather
conditions. Lubricate mower according to the instructions provided. In the event of prolonged
work stoppage, it is essential to lubricate all elements regardless of the period of the last
lubrication process. Additionally before the winter period apply grease to hitching system
pins.
5.6 LUBRICATION
Machine lubrication should be performed with the aid of a manually or foot operated grease
gun, filled with generally available permanent grease. Before commencing lubrication insofar