PRONAR PRONAR PDT260, Operator'S Manual

Page: 63 / 97

SECTION 4 Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340
4.19
TABLE 4.2 Swath width
Mower model PDT260 PDT300 PDT340
Swath width [mm] 1 200 / 1 600 1 200 / 2 000 1 500 / 2 400
To adjust swath guide position:
•
Loosen counter nuts (7) and bolts (5),
•
Move arm (3) as required, tighten bolts (5) and secure with counter nuts (7),
•
Loosen counter nuts (7) and bolts (6),
•
Set the height and angle of the disc (4), tighten bolts (6) and secure with counter
nuts (7).
Proceed the same way with the opposite swath guide.
Two swath guides installed on the cutting unit's support frame of PDT300 and PDT340
mowers are used to adjust the swath width - figure (4.11). each swath guide has two moving
discs.
Suitable setting of both swaths guides allows for a stepless adjustment of swath.
Minimal and maximal swatch width is given in table (4.2).
To adjust swath guide position:
•
loosen counter nuts and adjustment bolts (8),
•
move arm (5) as required, tighten bolts (8) and secure with counter nuts,
•
tilt swath guide outwards and remove the chain (6) from the arm,
•
rotate the swath guide as needed and put the appropriate chain link (6) in the arm
catch (5),
•
Unscrew and remove the securing bolt (10),
•
pull shaft until you have free access to the spacer rings (7)