10
Mortar
Concrete
Bearings
Additional safety instructions
• Only
fill
or
empty
the mixing drum when the motor is running.
• Check the
stability
of the mixer.
Preparing material for mixing:
1.Pour in water and few shovels full of aggregate (sand,
gravel, ...).
2. Add a few shovels full of binding agent (cement, lye, ...).
3. Repeat steps 1 and 2 until you reach the proportions required
for mixing.
4. Allow material to mix thoroughly.
Have a professional advise you regarding the composition and
quality of the material being mixed.
Emptying the mixing drum:
Hold the rotating lever or handwheel tightly
1.
Unlock rotating mechanism or step on brake
2.
Slowly tilt mixing drum
TRANSPORT
Pull plug each time before transport.
Point the opening of the mixing drum downwards during
transport or storage.
STORAGE
In order to increase the service life of the concrete mixer
and operate it without glitches, the rotating mechanism
should be treated with an environmentally compatible spray
oil before the mixer is put into storage for unusually long
periods.
CLEANING
Additional safety instructions
Pull plug each time before cleaning.
• Switch off machine and pull plug if you have to touch the
machine (with hand, brush, scraper, rag, etc.) while cleaning it.
• Protective devices removed for cleaning must be properly
remounted before starting the machine.
• Do not spray water directly on the motor or the switch, nor on
the ventilation apertures in the motor housing.
Notes on cleaning:
• Before taking a
break
and after
finishing work,
clean the
concrete mixer inside and out.
• Do not pound on the mixing drum
with hard objects
(hammer,
shovel, etc.). A dented mixing drum impairs mixing operations
and is difficult to clean, besides.
•
To clean
the inside of the drum, put in some water and a few
shovels full of gravel and set the drum to revolving.
• Remove any
concrete or mortar
left sticking to the teeth of the
axle-drive bevel gear or the crown gear segments immediately.
MAINTENANCE
The concrete mixer requires practically no maintenance.
The mixing drum and drive shaft are bedded on ball bearings
with permanent lubrication.
Never grease the ring gear!
To preserve the value of the mixer and increase its
service life, handle it as described in “Transport and storage”.
Furthermore, the concrete mixer should be checked regularly for
signs of wear and tear or functional deficiencies. This applies
especially to moving parts, screw connections, protective
devices and electrical parts.
REPAIR
Pull plug each time before doing repair
work.
• Switch off machine and pull plug if repair work should be
necessary. Do not start machine during repair work.
• Protective devices removed for repairs must be properly
remounted before starting the machine.
• Only the manufacturer or companies authorised by the
manufacturer may perform repair work on electrical parts or
on parts which affect the space needed to mount electrical
equipment.
• Use only unaltered original spare parts. Otherwise, the
manufacturer will assume no liability.
I
I
PROF_IM_CONCRETE MIXER PROF 130MIX 130L 600W_ 21NN.indd 10
PROF_IM_CONCRETE MIXER PROF 130MIX 130L 600W_ 21NN.indd 10
1.6.2021 20.04.00
1.6.2021 20.04.00
