2-6 PRODIGIT
2-13-1 STORE procedure:
2-13-1-1 Set the load status and load level from load module within the mainframe
respectively.
2-13-1-2 Press the STORE key on the front panel, the STORE LED annunciator is
flashing (about two times every second) to indicate ready to store. Press
Store key again or wait for about 20 sec to exit the store operation.
Press one of the state 1-5 key, the appropriate state key's LED annunciator will be lit
immediately, the load level and status of 33501 series load module is stored into the EEROM
memory this time. then the STORE LED annunciator turns to OFF, it means the STORE
procedure is completed.
Note:
After press the STORE key, the STORE LED annunciator will flash for 20 seconds, if the
STATE 1-5 key is not pressed within this 20 seconds, the STORE LED annunciator will be
OFF, it indicated the STORE process is not available now, please repeat the STORE
procedure for a new STORE operation.
After press the STORE key, then press the STORE key, the STORE LED annunciator will be
blank, it indicate the STORE process is not available.
After press the STORE key, it is available and useful to operate the front panel key on the
33501 series Electronic load . However, the STATE LED will be OFF if any key on any load
module is operated, this indicates the front panel state of load module is not the same as
STORE state.
2-13-2 STORE function:
Please refer chapter section on the 33501 series electronic load module operation
manual to more detail operation flow-chart for store and recall operation.
It can store up to states of 33501 series load module setting simultaneously, if you
store 2 different states in the same state key, the later state will overcome the
previous state, it acts as update the new data.
2-13-3 RECALL operation:
2-13-2-1 For 33501 series, using UP and Down key to select the Memory Bank,
then follow the procedure for the Memory Recall operation.
