PL-6930 / PL-7930 Series User Manual
5-8
Extended Memory Testing
Specifies whether a test for the Extended Memory needs to be executed at the system starting-up. The test
types are listed below. The factory default setting is [Just Zero it].
[Normal] Normal test
[Just Zero it] Simple test
[None] No test
Show CMOS Checksum Error
Specifies whether you need to display the errors in case CMOS Checksum Error occurs. The choice
is [Enabled] or [Disabled]. The factory default setting is [Disabled].
Clear CMOS Data Area
Specifies whether you need to Clear CMOS Data Area. The choice is [Enabled] or [Disabled]. The factory
default setting is [Disabled].
Power On Delay
Specifies whether the system waits during boot-up. Select from [Enabled] or [Disabled]. When [Enabled] is
selected, the system waits about 4 seconds during boot-up. The factory default setting is [Disabled].
•
If a USB device such as USB memory is connected to the PL when the PL is started, the follow-
ing phenomenon may occur, depending on the device:
•
It takes about 1 minute before the OS starts up.
•
The PL does not recognize the USB device.
These problems may be solved by setting [Power On Delay] to [Enable].