HU-TX500-TECH
89
TX500 series technical manual
LED indications and switch settings:
C
O
N
F
IG
7
6
5
4
3
2
1
0
7
6
5
4
3
2
1
0
LK
AC
SP
HD
ACT
R
E
S
E
T
RST
POK
Switch number
Function
Normal
setting
7
Ethernet address, DHCP (Up), Fixed in Network.ini file (Down)
DOWN/ON
6
TEST MODE (ON = ENABLED)
In test mode the system runs from a RAM copy of the config file
allowing the config file to be copied or overwritten using FTP
transfer. The RAM copy is a copy of the last data written to the
config file since the 2330 was reset. The 2330 will need to be reset to take
note of each change of the switch position
.
UP/OFF
5
Remote logging screen enabled (Down)
UP/OFF
SW3
4
Set audio embedder – Not Present (Down), Present (Up)
3
Audio take/lead. Take enabled (Up), lead enabled (Down)
DOWN/ON
2
Set vision mixer type – ICON (Up) or Snell and Wilcox (Down)
UP/OFF
1
OFF = Normal Gain Mode , ON = PGM Gain Mode.
In PGM Gain mode any adjustments to the gain will not be applied to the
PGM bus until the next transition (Take). Note this makes the PGM button
(in audio set up) on the Main TX panel obsolete
UP/OFF
SW2
0
Single audio over mode (Down)/Multi-over mode (Up)
UP/OFF
LED
FUNCTION
NORMAL
STATUS
LK
Ethernet link OK
Yellow
AC
Green when Ethernet link active
Off
SP
Ethernet speed, Red=100Mbit
Red
HD
Yellow when Hard Disk being accessed
Off/flashing
ACT
Module active
Green
RST
Red when Module in reset
Off
POK
Power OK
Green
