202
Issue 21
TX500 series technical manual
The following rules apply whether changed from a panel (hard or soft) or automation:
•
Adjusting PGM bus audio will change the audio for PGM/AUX1/AUX2 busses for
the selected PGM bus channel but will only change the PST bus if the PST bus has
a different channel selected to the PGM bus.
•
Adjusting the PST bus audio will only change the PST bus audio.
•
Adjusting the AUX1 bus audio will change the AUX1/AUX2 busses for the selected
AUX1 bus channel but will only change the PST/PGM busses if the respective
selected channels on the PST/PGM busses are different to the AUX1 bus.
To use the above feature on a manual TX panel, V3.11 or above software for the hard panel
or V1.18 or above software for the MCM soft panel will need to be used.
When this flag is disabled (0), the default setting, the routing/gains are applied to all busses
for that channel no matter which bus it was set on.
The ‘AudioGainMode’ value allows the gains to be applied according to the input channel
routing (0, default) or directly to the audio outputs (1).
The ‘UseExtendedAudioMsgPort?’ value allows the separate audio routing/gain functionality
to be used on an MCM soft panel. There are two configuration values, one for panel port 1
and one for panel port 2. Setting this value to 1 will allow an MCM soft panel (must be MCM
V1.18 or above) to use the separate audio routing/gain features. If a hard panel or MCM soft
panel V1.17 or below is being used on a panel port then the respective setting for that port
must be set to 0 (zero), the default.
