PRISMJET 54 Gen2, Operation Manual

Page: 118 / 305

Handling the printer PrismJET 54 Gen2 OPERATION MANUAL
128 4.2 Media
NOTE
• "PF Adjust" requires at least 15.7 inches (400 mm) printable width. Before printing, make sure that
there is sufficient width on the media. If printable width is less than 15.7”, your printer will not
print. Printable width on the media can be adjusted by changing CR origin and side margin (left and
right side margin) settings.
5.1.3 Side Margin menu
,
5.1.5 Media Width menu
,
5.1.8 Origin menu
4.2.6.1 Automatic PF adjustment method
1. Press the [+] key or [–] key to select “PF1: Auto”.
a. Press the [Enter] key on the operation panel.
• The printer performs an automatically PF adjustment.
• If the print defect persists after automatic PF adjustment, perform manual PF adjustment.
4.2.6.2 Manual PF adjustment method using adjustment print
4.2.6.2 Manual PF adjustment method using adjustment print
You will need a ruler to perform this adjustment.
1. Press the [+] key or [–] key to select “PF2: Initial Print”.
a. Press the [Enter] key on the operation panel.
• “Feed Length: 250 mm” is displayed on the operation panel.
TIP
•The length of media that is fed (feeding length) for Initial Print is normally set at 250 mm.
•If you increase the feeding length, the accuracy of the Media feed adjustment improves.
To change the feeding length, press the [+] key or [-] key on the operation panel and change the set value.