Prinzen PSPC5, Service Manual, Page: 69 / 73

HATCH TRAY DENESTER
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 69 of 73
DENESTER STOP POSITION
The stop position of the tray denester is
determined by the stop sensor. When the tray
denester stops, the denester blocks are at the
lowest position and the crank position is
completely vertical.
Follow below procedure for stop position
adjustment:
10. Press the emergency button.
11. Loosen up the detection bolt.
12. Change the position of the detection bolt
on the crankshaft. Tighten up the
detection bolt.
13. Pull the emergency button and start the
system by pressing the start button twice.
14. As soon as the outfeed conveyor is
running, set the selector switch to INCH.
The denester makes one complete stroke
and stops in the bottom position.
15. Check the lowest position. At this position
the tie rod and the crank should be
vertical.
16. Repeat 10 to 15 until the tie rod and crank
are in the vertical position.
TIE ROD ADJUSTMENT
The tie rods (17) are factory set. We advise
you to consult Prinzen before adjusting this tie
rod!
11
12
15
14
14
10
17