Prinzen PSPC5, Service Manual, Page: 56 / 73

OUTPUT CONVEYOR
Page 56 of 73 SERVICE MANUAL PSPC5 SM-PSPC5-01-E/12-2007
ADJUSTMENTS OUTPUT
CONVEYOR
TRANSPORT BELT TENSION
Adjust the tension of the transport belts in such
a way that they won’t slip on the drive rollers
during start up and during normal production
with full load.
Loosen up the tensioning roller lock bolts (1)
on both sides of the output conveyor. Turn the
tensioning bolts (2) Clock Wise for more belt
tension and Counter Clock Wise for less belt
tension.
Adjust on both sides of the conveyor the same!
The distance between the lock bolt and the
end of the conveyor (3) must be the same on
both sides of the conveyor.
ATTENTION!
A too high belt tension may result in a
damaged belt or wear on rollers and bearings.
30 CELL TRAY GUIDE
Pull the 30 cell tray guides (4) up and slide
them towards the end of the conveyor for
guiding the 30 cell trays.
When hatch trays are used, slide the guides
towards the denesters until they move down.
HATCH TRAY GUIDE
To adjust the guides (5) for the hatch trays,
loosen up the 3 nuts (6) and reposition the
guides. Tighten up the 3 nuts afterwards.
HATCH TRAY DETECTION
The sensor (7) at the end of the outfeed
conveyor detecting the hatch trays should also
be able to detect an empty hatch tray. Position
an empty hatch tray at the end of the conveyor
and make sure the sensor is ON. Adjust by
loosening up the 2 lock nuts (8) and
repositioning the sensor. Tighten up the lock
nuts afterwards.
For sensitivity adjustment of the sensor see
adjustment of
photo switches in this chapter.
1
6
6
5
5
2
2
3
4
4
6
8
7
8