Prinzen PSPC5, Service Manual, Page: 45 / 73

PACKER
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 45 of 73
MAIN DRIVE CHAIN TENSION
The chain tensioner (30) of the main chain is
spring loaded. Because of the position of the
fixation bolts (31), when the tensioner is
completely to the right it is still possible to push
in the tensioner with 10 mm (by the chain).
When the chain tension is too low move the
complete chain tensioner to the left.
To release the chain tension, take out the lock
pin (32) from the rear of the tensioner, push
the green chain tensioner in and place the lock
pin into the lock hole (33).
LOOSEN UP TAPER LOCKS
To loosen up the connection between a taper
lock and a shaft, loosen up all 5 bolts (40)
approximately 5 mm. Remove 2 bolts
completely and place them into the threaded
holes (41). Tighten up those 2 bolts to loosen
the connection with the shaft.
TIGHTEN UP TAPER LOCKS
Tighten up the bolts crosswise. Do this step by
step. As soon as a bolt is a bit tight, tighten up
the next bolt according to the following order:
1-3-5-2-4-1 (see alongside drawing).
30
31
32
33
40 41