Prinzen PSPC5, Service Manual, Page: 42 / 73

PACKER
Page 42 of 73 SERVICE MANUAL PSPC5 SM-PSPC5-01-E/12-2007
ADJUSTMENTS PACKER
INFEED BELT TENSION
Adjust the tension of the belt in such a way that
it won’t slip on the drive roller during start up
and during normal production with full load.
Loosen up the tensioning roller lock bolt (1).
Turn the tensioning bolt (2) Clock Wise for
more belt tension and Counter Clock Wise for
less belt tension.
Make the same adjustment on both sides of
the conveyor! The distance between the lock
bolt and the end of the conveyor (3) must be
the same on both sides of the conveyor.
ATTENTION!
A too high belt tension may result in a
damaged belt or wear on rollers and bearings.
GATE BLOCKERS
Gate blockers prevent the possibility of 2
smaller eggs entering 1 gate.
When smaller eggs are produced keep all gate
blockers in the infeed gates (4).
When the produced eggs are becoming bigger
remove every other gate blocker (5).
As soon as most of the produced eggs are big
and the infeed of eggs get stuck by the gate
blockers, remove all gate blocker (6).
GATE EGG DETECTION
The sensors detecting the eggs at the gate are
adjustable in height. Adjust this height when
the machine is stopped. The distance between
the roller (7) underneath the sensor and the tip
of the sensor (8) must be approximately 95
mm.
When the roller track is running the sensor
should not detect the rollers of the roller track!
For sensitivity adjustment of the sensor see
adjustment of
photo switches in this chapter.
2
1
3
4
5
6
8
7