Prinzen PSPC5, Service Manual, Page: 43 / 73

PACKER
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 43 of 73
ROLLER TRACK STOP
POSITION
When the machine is normally stopped (stop
sensor must be ON), 1 shaft with rollers (9)
must be at the position of the mark in the frame
(10).
To adjust this position, adjust the position of
the drive shaft of the roller track (11) in the
main drive.
Loosen up the 5 bolts of the taper lock (12)
and place 2 bolts into the threaded holes to
release the shaft from the taper lock. See
loosen up taper locks further on in this chapter.
By hand move the roller track forward or
backwards until one shaft with rollers is exactly
at the position of the mark.
Place back the 2 bolts and tighten up the taper
lock to the shaft. See
tighten up taper locks
further on in this chapter.
FLAP SHAFT STOP POSITION
When the machine is normally stopped, the
position of the flaps (13) must be parallel with
the mark in the frame (14).
To adjust this position, adjust the position of
the flap shaft (15) in the main drive.
Loosen up the setscrew of the gear (16) to
release the shaft from the gear. By hand rotate
the flap shaft until the flaps are exactly parallel
with the mark. Tighten up the setscrew.
10
9
12
11
14
13
15
16
ON