Prinzen PSPC5, Service Manual, Page: 30 / 73

INSTALLATION
Page 30 of 73 SERVICE MANUAL PSPC5 SM-PSPC5-01-E/12-2007
42. The vacuum head stops at its tray set
position. The tray set position depth is
factory adjusted with a hatch tray. See
adjustment procedure of the
vacuum head
tray set position .
43. The suction cups of the vacuum head must
fit into the tray.
44. In case of not centered suction cups,
change the position of the output conveyor
until the suction cups of the vacuum head
are on the correct position above the tray
(the bolts that fasten the output conveyor
on the supporting beams are only loosely
fixed).
45. While changing the position of the output
conveyor make sure that the output
conveyor is parallel with the packer.
46. After adjusting the output conveyor
position tighten up the bolts (2 per beam)
that connect the output conveyor to the
packer.
43
43
45
45
46