Power Supply Mode
1.
Function(Mode) set-up
Set up part.
ⴜ
of the LCD indicator changed or designate to POWER SUPPLY by pushing
ⵐ
SELECT button
in the front part of the machine.
2. Target voltage set-up
Make the arrow(
ⶺ
)
located in the Battery Voltage / CV of part.
ⴘ
by pushing
ྀ
ENTER button.
You can go on to the next work by pushing
ྀ
ENTER button again after set-up the maximum battery target
charge voltage to 15.6V by using
ཱྀ
UP button and
ྂ
DOWN button.(12V battery is set-up to 6 cells and
the maximum target charge voltage 2.6V per 1 cell)
3. Hourly supply current set-up
You can go on to the next work by pushing
ⵑ
ENTER button again after set-up the exterior showed
regenerated battery capacity to the 1/10 value by using
ⵒ
UP and
ⵓ
DOWN button when the arrow
is located to the Capacity (Ah) / Current (A) of part.
ⴙ
.
(Warning : That is not the capacity input.)
4.
Time Set-up
Set-up total working time by using
ⵒ
UP and
ⵓ
DOWN button when the arrow is located in Run Time (H:M) of part.
ⴚ
.
5. Internal Resistance / CCA value measure
Refer to “4. Internal Resistance / CCA value measure” in “Regeneration Mode” of
previous page.
6. Start and Pause
You can start the work by pushing
ⵔ
START / STOP button in front part of the machine after input 1~4 topic is
completed and check the Internal Resistance and CCA measure of before regeneration. You can pause the work
by using
ⵔ
START / STOP button during the work.
7.
Progress condition display
The supplied voltage is displayed in
ⴘ
Battery Voltage / CV under the WORK part, the hourly
current amount in
ⴙ
Capacity(Ah) / Current(A) and the elapsed time of previous set-up time is
displayed in
ⴚ
Run Time(H:M) in real time.
Control Button
SELECT Button
LCD Indicator
SET
The way of input Set Values
SET
SET
SET
Caution
: This Mode is a manual control mode for expert user who has a wealth of information about battery regeneration, and
he can regenerate and charge battery as he wanted. The accident damaged to human, battery or machine cannot be
protected from service or compensation if the none-expert user uses the machine without enough knowledge about manual.
This mode can control set-up voltage, hourly input current, and progress time manually for special battery which is
not included in battery type, sleeping battery which has lowered voltage due to non-use for a long time and some
battery only need a little regenerate/charge. It is a special power supply function for lead-acid batteries.
or
or
or
