Power One AURORA PVI-6000-OUT-US-W, Installation And Operation Manual

Page: 22 / 77

User Manual Page 22 of 77
(PVI-6000-OUTD-US-W Rev.2.0)
3.5 Before performing electrical connections
WARNING:
Electrical connections shall be performed only after the
AURORA inverter is securely mounted to the wall.
WARNING
: The connection of the AURORA inverter to the electrical
distribution grid must be performed by qualified operators and only after
receiving authorization from the utility that operates the grid.
WARNING:
For a step-by-step description of the correct procedure,
please, read and follow the instructions provided in this section (and its
subsections) while observing all safety warnings. Any operation that
does not comply with the instructions can lead to conditions hazardous
to personnel and/or equipment damage.
WARNING:
Always respect the nominal ratings of voltage and current
defined in Section 8 (Technical Characteristics) when designing your
system. When designing the system make sure the following limits are
never exceeded:
¾ Maximum DC voltage input: 600Vdc under any condition.
¾ Maximum DC current input to the 2 parallel input: 32Adc under
any condition.
WARNING:
Check the National and local standards and regulations to
make sure your electrical installation and design are in compliance with
them.
NOTE
: In accordance with the typical assembly diagram (see Fig. 9) an
AC disconnect switch with the overload protection (breaker) must be
used to connect the AURORA inverter to the grid. Recommended ratings
for the disconnect switch are 40A, 240VAC.