Posch rz-600, Operating Instructions Manual

Page: 9 / 20

En
vir
onm
entally Friendly Technolo
gy
Page 7
Operating the Circular Saw
Caution!
Don´t use the emergency stop
support continuous to switch off the
machine.
2.
After using the emergency stop you
must switch off the pto. Then retract the
emergency stop pedal in the starting
position.
Longitudinal cutting
Modification for longitudinal cut-
ting
Caution!
Before modification switch off
machine
▼ For longitudinal cutting, a saw blade
diameter of 500 mm is necessary, requir-
ing the following steps:
Fold the table forward
Fig. 5 - Longitudinal cutting modification
• Press down stop pin.
• Slide the table forward to the stop.
• Push down the stop pin again and
slide the table into the frontmost
position.
• Fold the table up and lower onto
ground. Stand on the side of the
machine, holding the side of the table
at the holding device.
▼
Remove the saw blade from the drive
shaft. (see Fig. 9 - Saw blade change)
Hexagonal bolt
Saw blade guard
Stop pin
Log gripper