Posch rz-600, Operating Instructions Manual

Page: 12 / 20

En
vir
onm
entally Friendly Technolo
gy
Page 10
Operating the Circular Saw
• Hold down the tensioning flange
with the open-end spanner supplied.
3.
Remove tensioning flange.
4.
Change saw blade. We recommend
the use of the following saw blades:
5.
Fold the saw table back up.
Transportation
▼ Switch off pto drive.
▼ Slide the table back until it latches
into position.
▼ Mount circular saw on three-point
linkage.
▼ Lift circular saw with tractor hydrau-
lics.
▼
The highway code must be observed
for public road transportation.
Item no. Designation
for log cutting
Saw blade Ø 60 cm, boring Ø 30 mm,
coarsely toothed
Z1300050 chrome plated
Z1300060 chrome vanadium
Z1300072 carbide tipping
for longitudinal cutting
Saw blade ø 50 cm, bore ø 30 cm, finely toothed
Z1300030 chrome plated
Z1300035 chrome vanadium
Z1300041 carbide tipping
Table 4: Suitable saw blade types
▼ An appliance light must be attached
to the rear of the machine.
• Order no. F000 1418
▼
The maximum transportation speed
is
15 mph!
Additional Equipment
Wheels
Fig. 10 - Wheels
▼ Order no. F000 1419
▼ By using the wheels, the machine can
be moved along.
• Latch the table into position.
• Lift the machine on the operating
side until the wheels move forward.