En
vir
onm
entally Friendly Technolo
gy
Page 9
Operating the Circular Saw
▼
Attach longitudinal guard on frame.
Fig. 8 - Longitudinal cutting guard
• Bolt the receiving plate to the table.
• Position the longitudinal cutting
guard and the clamping piece into the
receiving plate and secure with the
hexagonal bolt.
Caution!
Use longitudinal stop and
pushing stick for longitudinal cutting.
Caution!
Longitudinal cuts may only be
made with the table latched in position.
Longitudinal stop
Longitudinal cutting guard
Clamping piece
Receiving plate
Stop pin
Saw Blade Change
(see Fig. 9 - Saw blade change)
Caution!
Disconnect circular saw from
mains before saw blade change!
Fig. 9 - Saw blade change
1.
Fold the table forward
• Press down stop pin.
• Slide the table forward to the stop.
• Push down the stop pin again and
slide the table into the frontmost
position.
• Fold the table up and lower onto
ground (see Fig. 5 - Longitudinal cut-
ting modification).
2.
Loosen hexagonal nut from drive
shaft.
Hexagonal nut
Tensioning
Stop pin
Open-end spanner
flange
Summary of Contents for rz-600
Page 20: ... LEIBNITZ Your Posch Dealer ...
