System Installation
ROBO-8716VG2A User’s Manual
3-3
3.2 Main
Memory
ROBO-8716VG2A provides two DDR-SDRAM DIMM slots to support 2.5V DDR-
SDRAM as on-board main memory. The maximum memory size can be up to 2GB.
Auto detecting memory clock according to BIOS CMOS settings.
For system compatibility and stability, don’t use memory module without brand.
You can also use only one double-sided DIMM in either one DIMM slot or two
single-sided DIMM in both slots.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install your DRAM
module into memory socket. Before locking, make sure that all modules have been
fully inserted into the card slots.
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup
to upgrade your system performance without acquiring technical information.
Memory frequency / CPU FSB synchronization
ROBO-8716VG2A support different memory frequencies depending on the CPU
front side bus and the type of DDR DIMM.
CPU FSB
Memory Frequency
800MHz 400MHz
533MHz 333/266MHz
400MHz 266MHz
3.3
Installing the Single Board Computer
To install your ROBO-8716VG2A into standard chassis or proprietary environment,
you need to perform the following:
Step 1: Check all jumpers setting on proper position
Step 2: Install and configure CPU and memory module on right position
Step 3: Place ROBO-8716VG2A into the dedicated position in your system
Step 4: Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that your SBC is properly inserted and fixed by mechanism.
Otherwise, the system might be unstable or do not work due to bad contact of
PICMG 1.2 PCI bus slot.
