ēno play
Before beginning to install the ēno play components, measure and plan cable routing for the ēno
play amplifier power source and audio input. PolyVision provides a 25 ft (7629 mm) audio input
cable, and a power connector with a 6 ft (1829mm) cable plus a 10 ft (3048mm) power cable
extension.
Cable routing considerations include:
•
Where is the closest AC power outlet?
•
Will the ēno play installation support a guest or a permanent audio input source, or both? If using
the guest audio input connector, refer to “Using the guest audio input connector”.
•
If using a permanent audio input source, Where is the source located? Is it above, below or to one
side of the whiteboard?
•
How is the whiteboard mounted: directly to a wall, or to an adjustable height system?
Cable routing for whiteboards mounted directly to the wall
To route the amplifier power or permanent audio input cable for whiteboards that will be mounted
directly to the wall:
1. Consider the locations of the power and audio sources to determine cable length
requirements and whether to mount the amplifier on the left or right lower corner of the
whiteboard.
2. Connect the permanent audio input cable and power cable to the amplifier at the same time
that you connect the driver pack cables.
3. As appropriate and to the extent possible, route the power and audio cables in the same
cable bundle as the driver pack cables across the back of the whiteboard.
4. Add tie holders, cable ties and tape as necessary to secure all cables where they cross the
back of the whiteboard.
Note: For more details, refer to “Add cable ties and tape”.
8 of 38
2002480-001 Rev C
Installation and Operation Guide