ēno play
2. Position the tie holder one inch below a driver pack and one inch towards the center of the
board so the tie holder holes to run approximately vertical and horizontal with the board.
3. Press the tie holder to the board.
4. Install a tie wrap through the vertical holes in the holder and capture the driver pack wires
driver pack cable ties
5. Ensure there is about 1/2” (13mm) service extension between the tie holder and driver pack
then tighten the tie wrap.
IMPORTANT
: Make sure the service extension or tie wrap are not pointed toward the
whiteboard or touching it.
6. Repeat for the second driver pack.
Install the amplifier cable tie
To secure cables that are connected to the amplifier, add a cable tie at the amplifier:
1. Remove self adhesive back from a tie holder.
2. Position the tie holder about 2” (50mm) from the amplifier so the tie holder holes to run
approximately vertical and horizontal with the board.
3. Press the tie holder to the board.
18 of 38
2002480-001 Rev C
Installation and Operation Guide
