ēno play
Install the amplifier
Important Note
: The location of the amplifier is important. Install the amplifier in either the lower left
or the lower right corner of the whiteboard and no other location.
To install the amplifier:
1. Determine which side of the whiteboard provides the best access for audio input and power
to the amplifier.
2. Using an alcohol wipe, clean the back of the ēno whiteboard where the amplifier will be
fastened.
3. Remove the self-adhesive backing from the amplifier.
Note
: Use care when mounting the amplifier and drive packs to the back of the whiteboard.
The supplied adhesive is intended to be permanent. If you need to remove or reposition the
components, additional supplies are provided. Refer to “Removing and replacing the cable tie
holders, driver packs or amplifier”.
4. Press the amplifier in place for 15 seconds.
Connect driver pack cables to the amplifier
To connect driver pack cables to the amplifier:
16 of 38
2002480-001 Rev C
Installation and Operation Guide