ēno play
2. Use the illustrations on the template to select the template notches that are appropriate for the
type of whiteboard mounting solution in your installation.
3. Using an alcohol wipe, clean the area about 3” (76mm) below the correct template location.
4. Remove the two self-adhesive backings from a driver pack.
Note
: Use care when mounting the ēno play amplifier and drive packs to the back of the
whiteboard. The supplied adhesive is intended to be permanent. If you need to remove or
reposition the components, additional supplies are provided. Refer to “Removing and
replacing the cable tie holders, driver packs or amplifier”.
5. Orient the driver pack with the wires facing the floor. Note the two tabs at the top of the driver
pack.
6. The driver packs are magnetized. Position the driver pack against the template notches at a
30
0
to 45
0
angle without touching the adhesive to the board.
Important Note
: Make sure the registration is correct before proceeding. Magnets in the driver
packs will pull the assembly to the board.
7. While holding the driver pack tabs against the template notches, rotate the drive pack
adhesive into contact with the whiteboard.
8. Press hard on the driver pack for 15 seconds.
PolyVision
2002480-001 Rev C
11 of 38
