ēno play
4. Install a tie wrap through the vertical holes in the holder and capture both driver pack wires
(and the power supply and permanent audio input cables if appropriate for your installation).
Refer to “Plan power and audio input cable routing”.
amplifier cable tie
5. Ensure there is about 1/2” (13mm) service extension between the tie holder and amplifier then
tighten the tie wrap.
IMPORTANT
: Make sure the service extension or tie wrap is not pointed toward the
whiteboard or touching it.
Install a cable tie at the center of the whiteboard
To install a cable tie at the center of the board:
1. Remove self adhesive back from a tie holder.
2. Position the tie holder about one inch below the horizontal line created by the two driver pack
tie holders so the tie holder holes to run approximately vertical and horizontal with the board.
3. Press the tie holder to the board.
PolyVision
2002480-001 Rev C
19 of 38
