Undo
/
Redo
– Every time you make a mistake (add/delete a step, make changes to
parameters) you can go back (or forth). When the Shift key is pressed, these actions are
available under the bottom screen buttons.
Session Save
and
Reset
– At any given time you can save and recall the current state of your
pattern. It’s especially handy to have a lifebuoy during a live performance. Just hit that Save
button!
Copy
/
Paste
– Select any number of steps (remember to hold the shift button to select
multiple steps) and copy them into the same or another pattern.
Turn Preview
– While the sequencer is stopped, turn one of the knobs to hear the change
parameters immediately.
Step Preview
– Click down and hold the encoder, then press a step pad containing a note to
hear it.
Easy Selection
– Select one step, a block of steps, a single track, or an entire pattern.
Mute
and
Solo
– You can perform these actions to all the audio and MIDI tracks separately
using the dedicated function pads.
Reverse
sample – Set the sample endpoint before its start point to reverse its playback.
Swing
– This is a per-track function. But you can apply it to all the tracks at the same time
for global swing.
Default Values
– Double-clicking a screen button corresponding to the selected knob
parameter (and/or its automation) will restore its default value.
Decaying
sample cut – When a long sample sounds through (decaying) after stopping the
sequencer, you can cut it by touching the Master Volume knob.
Portability
– Polyend Play runs on 5V/1A and can be powered from a power bank.
Tracker
integration – Go to the Main menu > MIDI > CC Mapping -> Channel and select Set
Values for Polyend Tracker to enable integration mode for the Polyend Tracker Standalone
Audio Workstation.
Introduction
